ICC2-VDC RS-232 Display Controller/Tuner

Specifications

Physical

Size: 8.5" [216mm] wide x 1.75" [38mm] high (1RU) x 6.0" [153mm] deep
Weight: 24 oz [680 g]
Enclosure: All aluminum with durable black powder coat paint
Mounting: Mounts above or below TV

Front Panel

Push Buttons: Channel up and down, Volume up and down, and Power
Power LED: Red LED lights when TV is on, blinks if TV power is out of sync
Net LED: Green LED for iC-Net bus, flashes once per second if network is active
IR In LED: Red LED lights when receiving IR commands from remote
IR Out LED: Red LED lights when sending IR commands
Volume Up/Down: Buttons adjust volume of IRC audio output
Channel Up/Down: Buttons select list of channels stored in IRC Tune Ring
Sensor Window: Internal sensors receives 38 KHz or 57 KHz commands from IC-RC remote

Rear Panel

Power In: 2.1mm coaxial jack (inside center conductor positive), 350 mA maximum
11.5 to 15 VDC, 12 VDC typical (may be unregulated)
RS-232 Control: DB-9 male connector, baud rates from 1200 to 115,200 baud
Optional CC-232 RS-232 available to match specific makes and models
Antenna/Cable: 'F', female, 75 ohm impedance, RF from CATV system
iCC-Net network: carried over the same RF coax connection as TV channels
Receive: Mid-band VHF, 74.7MHz, sent from ICC-HE Head-End Network Controller
-25 to +35 dBmV signal level
Transmit: Sub-band, 5.6MHz sent to iC-Net Head-End
± 80 KHz max carrier deviation, +49dBmV nominal
A/V Inputs: Switchable under program control
Video: RCA female jack, NTSC composite
Audio: 2 RCA female jack, mono, 20K ohms impedance unbalanced
A/V Outputs: Provide channel or external input A/V to TV
Video: RCA female jack, NTSC composite
Audio: 2 RCA female jacks, mono, 1K ohms impedance, 20Hz to 20KHz response
0.5% maximum, 0.1% typical Total Harmonic Distortion
Output level: 500mV RMS typical output level (at max volume)
Volume control: 0 to -62 dB and mute in 64 steps
IR In: External IR sensor input jack (optional)

Onboard Tuner

Frequency Range: NTSC television 55.25 to 801.25 MHz, 62.5KHZ fine tune resolution
Tuning Modes: Broadcast, CATV, HRC, IRC
Maximum Input: +20dBmV
Video Gain: ±5% maximum, 2% typical
Video Phase: ±3 degrees maximum, 2 degrees typical

Includes

Space-saving 12 VDC 500 mA digital switching power supply (North American shipments only)

Options

IC-RC Wireless IR Remote
IR-RXC External IR Receiver, extends IR range or positions sensors for best reception
CC-232 RS-232 Control Cable (specify make and model)
Closures: Two solid-state switch closures, max 50 mA, 24 VDC, factory installed only Buzzer, internal, used for system-activated alerts
RK2 Kit for surface-mounting VDC

© 2008 Contemporary Research Corporation. All rights reserved.