ICC2-IRC IR Display Controller/Tuner

Installation

AC Power Test

1. Insert DC power supply plug into 12 VDC jack.
2. Plug power adaptor into AC wall outlet.
3. The Net LED should turn on and stay lit.

RF Coax and iCC-Net Operation

1. Connect the TV to CATV and observe quality of RF broadcasting. A low-quality CATV system can also affect performance of the iCC-Net commands. If needed, fix CATV problems before installing the system.
2. Connect the CATV RF Coax cable into the RF In input on the ICC2-IRC.
3. If the iCC-Net signal is operating, the Net LED will blink once per second.
4. Connect the RF loop cable from the RF Out jack to the TV’s RF connector (remember, you lose less than 1.5 dbmV by going through the ICC2-IRC’S internal RF tap).

AV Wiring

1. Connect audio and video outputs of the IRC into the audio and video inputs of the projector.
2. You may use the left or right audio output for a projector with mono audio, both for a TV with stereo audio (ICC2-IRC sound is mono).
3. Set the projector to its Video Input to view on-screen setup commands from the IRC.

TV Power Sensing

1. Skip if using discrete IR commands
2. Insert the CC-HSD Scan Sensor plug into the Power Sensor jack.
3. Turn on the TV using the TV’s power button.
4. Move the CC-HSD sensor block around the rear of the TV to pick up scanning signal from the TV’s horizontal transformer
5. Watch the Power Sensor LED as you move the sensor, stop moving when the LED lights steady.
6. Turn the TV on and off from its own power button, testing if the unit is reliably sensing power.
7. Mount the sensor to the TV, using the enclosed Velcro tape.

Sensing Tip: The best location for the sensor is usually on the lower left rear corner side corner (looking from the front), and it may help to rotate the sensor to search for best performance.

Discrete Codes Tip: Some applications, such as Zenith and Philips sets, use discrete power on and off, and do not use the sensors.

IR Control Codes

The ICC2-IRC has a database of IR control codes onboard. Set the unit DIP switches to the needed code, following instructions in the manual, or set using RS-232 control commands (T1) over the coax.

© 2008 Contemporary Research Corporation. All rights reserved.