ICC-PSC Philips SmartCard

Installation

1. Turn off TV and remove the existing SmartCard cover plate.
2. Disconnect the attached RF cable from the tuner input below the card.
3. Remove existing SmartCard slowly (RF cable is attached to card).
4. Attach included F to RCA adapter to the Cable/Antenna input on the PSC cover plate.
5. Connect included RCA cable from the Cable/Antenna RCA to the RF Input on the bottom side of the card.
6. Connect the include RCA cable from RF Out to the TV RF input:
   • ICC-PSC2 – Run the cable outside to the TV’s antenna input below the PSC card.
   • ICC-PSC – Connect the RCA cable to the RF In connector inside the SmartCard port, located below the card slot.
7. Gently but fully insert PSC card into the Philips Smart Card slot.
8. Attach PSC cover plate to TV – for ICC-PSC2 cards, make sure the RF Out cable fits into the cable slot at the bottom of the cover plate.
9. Turn on TV.
10. The Net LED should light and stay on, indicating power, but not iC-Net communication.
11. Com LED turns on when data link with TV is established, blinks when data sent from IR remote, front-panel buttons, or iC-Net commands.

RF Coax and iCC-Net Operation

1. Connect the CATV RF Coax cable into the ANT/CABLE jack.
2. If the iCC-Net signal is operating, the Net LED will blink once per second

   

As shown above, the RF Out cable on ICC-PSC2 series Smart Cards connects to the external Antenna F connector on the TV.

© 2008 Contemporary Research Corporation. All rights reserved.